12/28/2023 0 Comments Diy giant jenga game and storageA full-service remodeling and construction company. Rob Robillard is “The Concord Carpenter” Rob is a builder, general contractor, carpenter, woodworker, and editor of Concord Carpenter and ToolBoxBuzzĪs a General Contractor and carpenter, Rob owns and operates Concord Carpenter LLC. Note: There are other tools that can accomplish these tasks as well. I used a Forstner drill bit to bore two side by side holes, cleaned up the cut outs with a jig saw and then rounded over the edges on both sides with a router and a round over router bit. This allows me to close the box and store irt dust free or even stack it vertical.Ī well placed hand cut out will assist the person carrying this box. I used a table saw to cut a ¼” inch groove to accept a 3/16 birch plywood sliding lid. I purposely kept the two long sides and one end piece higher than the other end piece. Nails and glue assist in keeping all of the sides and bottom in place. You can also use biscuits, a traditional tongue and dado joint or finish nails.įor the sides of the box I chose to use Dominos and butt joints. A floating tenon, unlike traditional mortise and tenon joinery, is an insertable tenon in two opposing slots. To make the bottom panel of the box strong I used the Festool Domino Joiner DF 500-Plus to create a slot for a floating tenon. ![]() ![]() Lid: I measured and cut the lid once the box was assembled. I made a box that could store more blocks than I needed, I was not sure if I was going to make some extra parts or not. I wanted a strong and secure way to store the game as well as a platform to use when playing. I stacked all of the blocks together to determine an appropriate size for my storage box.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |